5 Common Problems Analysis for Ice Maker Machine from Professional Person

     When you buy ice machine for a time ,suddenly it has problems . As cube ice machine officer ,I will introduce you 5 reasons.

     1 .cause of bad ice machine ice knot 

     Check water flow-through is uniform , check the top of the uneven water holes are blocked . Check whether the spray nozzle clogging whether plugged scale cleanup .

     2 If cold bottle of water , or cold with ice maker refrigerator ?

    Not use ice machine , ice machine because power is relatively large , and sometimes may put that bottle nipped . Cryogenic refrigerator to freeze , refrigeration refrigerator temperature should gear tune larger, higher power , then it should be able to ice is good, but some of it needs a long time .

    3 When the ice is not water ice mechanism to how to do it ?

    Circulating pump should check to see if it is not working properly, if it is not broke , it is level probe may be short-circuited , the water level control head can determine whether there is water , it is through some of the signals needed to determine whether the water . 

    4 spray water on the ice machine and ice machine structure What is the difference ?

   1 ) Spray the ice machine pumps the water sprayed into the top of the evaporator , evaporator ice tray was mounted horizontally , hard ice : ice machine water water water rely on gravity flow through the upper part of the ice tray from the ice tray , ice vertical installation disk into produce ice spray is not relative to the hard reality.

   2 ) the efficiency of spray flow- no good .

   3 ) spray ice machine ice machine ice tray mold that is sideways , die down ; flowing style is bristling .

    5 ice machine dehydration short time is how it happened , why , and how to solve it ?

    Ice machine dehydration short time could be: ice plate probe right ; level probe deviation : water temperature ; inlet valve : pressure .

The solution is to put the ice sheet control pin to tune a tune , it should be transferred to the best thickness ; position to check the water level and water level probes are appropriate ; water temperature not higher than 32 ° C: see the water inlet valve is not normal ; pressure must be 20-80Psi.